Solo Pro (SRT)

To publish in SRT from LiveU Solo, you need to:

have a Solo (on firmware 7.2) or Solo PRO
select the right zone where SRT is active (see LiveU Solo Pro documentation)

You can find all this information in the Solo tutorial.

Create a new SRT ingest point in Studio

In the Live Source section (3) -> Encoders (push) (4) -> Select LiveU SRT (5).

Select The SRT Caller Destination Type
Add a new destination to your unit, and select SRT-OUT-Caller-Solo as your destination type:

Once you select that, you will get some SRT options to set:

Destination name: put whatever you want.
URL & Port: paste the URL provided earlier on Studio.
Stream ID: paste the Stream ID provided earlier on Studio.
Latency: This is the SRT latency to set. It should be about twice the round trip time between the LiveU Cloud and your destination - but its hard to know what that number is! for Most destinations on the internet, the default of 500ms should be just fine. If you know your destination is for any reason hard to reach, or you find the stream unstable, try a higher value here.
Codec: here you can choose, on Solo PRO only between H.264 (the default) or HEVC.

Go live on Solo.